It’s connected to one of the terminals of the motor and it’s is high when input 1 is high else it will be low. (Control signal received from a microcontroller or microprocessor) Output 1 (Pin No. This is an input pin to control the direction of the left motor. (in short, it enablers the left part of the ic) At the end of the pin description, there are two important notes. logic 0 or low voltage then the left part of the ic won’t work. This pin is an active-high when it receives high or logic 1 then it enables the left part of the ic and when it receives active low i.e. The functions of all 16 pins which are mentioned in the above pin diagram of L293D is given below. In this article, we are going to learn about the Pin Diagram of L293D, Functions of pins L293D, Working Principle of L293D, and Interfacing of L293D with Arduino and their code. we can apply 4.5V to 36V at pin 8 and to run the whole IC 5V should be applied at pin 16. Now I’ll explain to you why I had said that it’s magical IC because of its Dual H-Bridge Configuration it can operate over two voltages i.e. also, we can control the speed of the DC motors by applying the PWM signal at Enable pins shown in the pin diagram of L293D of the Motor Driver IC L293D. based on these control signals it controls the direction of rotation of the DC motors. It receives a control signal from microcontrollers such as Arduino, ESP32 Dev Module, etc. L293D can drive two DC motors simultaneously, with up to 600mA current in each channel. In this blog, we will discuss about L293D Pin Diagram its working, and its interfacing with Arduino.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |